ERS Integration

ACTIVE SHOOTER PROTECTION SYSTEM SETUP

The following steps are a guide to assist you in implementing your new emergency response shield protection system. If you have any questions, please reach out via our Live Chat or contact page.

STEP 1: INSTALLATION

To learn how to install the ERS in your school, view our video below.

*Note: The shields are 25lbs, make sure to use the included hardware only to mount your shield on either masonry or drywall.

 

STEP 2: TRAINING

Train your staff, faculty, and School Resource Officer with on of the training videos below!

*Both videos offer the same ERS training; however, if your school has protocols that differ from the DHS recommended, "RUN, HIDE, FIGHT" active shooter response protocol, select the second video.

ERS TRAINING WITH DHS "RUN, HIDE, FIGHT" PROTOCOL

ERS ACTIVE SHOOTER TRAINING

STEP 3: UPDATE YOUR SCHOOL'S EMERGENCY PLAN

Use the following checklist to make sure your active shooter emergency plan is up to date.

1. Add a map of where all shields are located.

2. Add a link or QR code to the training video; you can download the QR Codes below.

3. At the beginning of each school year, hold a staff training session where everyone watches the video, holds the shield, and gets a map of their locations throughout the school.

FRESH OFF THE WIRE

Suggested articles to explore.